Our paint stripper effectively removes all paints, stains and varnishes, even the most stubborn on all types of substrates. Paraffin-free and with a very low odour, it is ready to use. While competing products no longer work after a maximum of two hours, it remains active for up to 3 days.
Application temperature: +5°C to +30°C.
Consumption: 0.4 to 0.8 liters per m².
Non-flammable, non-corrosive.
PROPERTIES:
Without methylene chloride.
Gel stripper, does not run even on vertical walls.
Paraffin free, low odour, ready to use.
Removes even stubborn layers.
Active from 3 minutes of application up to 72 hours.
Non-corrosive.
Applicable in airless projection.
Inside and outside.
Deep stripping.
Non-flammable.
Does not darken the wood and does not attack the glass.
DESTINATION:
• Intended for all types of media.
• Eligible materials: single-component organic building paints, varnishes, thin films, plasters, thick and semi-thick plastic coatings, external thermal insulation, I3 and I4 waterproofing coatings.
RECOMMENDATIONS:
• The support must be dry and perfectly cleaned. Scratch the paint beforehand if necessary, to facilitate the action of the stripper.
• Wear goggles and gloves before handling.
TIPS:
• Doing a test before application allows you to know exactly the time of action of the stripper on the surface to be stripped and thus optimize your time and effort.
• On a surface of 20 cm², apply a thick layer then let the product react. Observe the stripper's work. Make a partial scraping over time to compare the result.
APPLICATION:
• Shake well before use. Apply a thick and regular layer which will guarantee an optimal result. Leave the stripper to act for 3 to 30 minutes, then remove the softened coating using a spatula, scraper or steel wool. Rinse with lukewarm water with a stiff brush.
• The application of a new finish (paints, varnishes) is possible after 24 hours.